uKit Explore
  • About uKit Explore
  • Quick Start
    • How to Install uKit Explore Arduino Library
    • uKit Explore v2 Pinout
    • Introduction to Grayscale Sensor and Frequently Asked Questions
    • Grayscale Sensor Calibration Guidelines
    • Grayscale Sensor Firmware Update
  • uKit Explore Function
    • Introduction to uKit Explore Library
    • Sensor
      • uKit eye lamp
        • setEyelightAllPetals(id,red,green,blue)
        • setEyelightPetals(id,petalsnum,petals)
        • setEyelightLook(id,face,times,red,green,blue)
        • setEyelightLookUntil(id,face,times,red,green,blue)
        • setEyelightScene(id,scene,times);
        • setEyelightSceneUntil(id,scene,times)
        • setEyelightOff(id)
      • uKit Ultrasonic Sensor
        • setUltrasonicRgbled(id,red,green,blue)
        • setUltrasonicRgbledOff(id)
        • readUltrasonicDistance(id)
      • uKit Infrared Sensor
        • readInfraredDistance(id)
      • uKit Touch Sensor
        • readButtonValue(id)
      • uKit Light Sensor
        • readLightValue(id)
      • uKit Sound Sensor
        • readSoundValue(id)
      • uKit Temperature and Humidity Sensor
        • readHumitureValue(id,choice)
      • uKit Color Sensor
        • readColorRgb(id)
        • readColor(id,color)
    • uKit Servo Motor
      • setServoTurn(id,dir, speed)
      • setServoAngle(id,angle,times)
      • readServoAngleNPD(id)
      • readServoAnglePD(id)
    • uKit DC Motor
      • setMotorTurnAdj(id, speed,time)
      • setMotorTurn(id,pwmDuty)
      • setMotorStop(id)
      • readMotorSpeed(id)
    • uKit Explore Onboard Hardware
      • Onboard button
        • button1.Update();
        • button1.clicks()
      • Onboard Buzzer
        • noTone(pin)
        • tone(frequency, duration)
      • Onboard RGB LED
        • setRgbledColor(red,green,blue)
      • onboard Battery Voltage Level
        • readBatteryVoltage()
      • onboard Gyroscope
        • IMU::init()
        • IMU::read()
        • IMU::getRawAccelX()
        • IMU::getRawAccelY()
        • IMU::getRawAccelZ()
        • IMU::getRawGyroX()
        • IMU::getRawGyroY()
        • IMU::getRawGyroZ()
        • IMU::getRoll()
        • IMU::getPitch()
  • Arduino Function
Powered by GitBook
On this page
  • Video
  • Tutorials
  • Connection

Was this helpful?

  1. Quick Start

Grayscale Sensor Calibration Guidelines

PreviousIntroduction to Grayscale Sensor and Frequently Asked QuestionsNextGrayscale Sensor Firmware Update

Last updated 5 years ago

Was this helpful?

Video

Tutorials

Grayscale Sensor Calibration Guidelines

Connection

For v1 uKit Explore main controller board, the 7PIN connectors is connected to Route and another end connected to JP16 terminal

For v2 uKit Explore main controller board, the 7PIN connectors is connected to Route and another end connected to X3

https://youtu.be/Px0Q4andkaQ