uKit Explore
  • About uKit Explore
  • Quick Start
    • How to Install uKit Explore Arduino Library
    • uKit Explore v2 Pinout
    • Introduction to Grayscale Sensor and Frequently Asked Questions
    • Grayscale Sensor Calibration Guidelines
    • Grayscale Sensor Firmware Update
  • uKit Explore Function
    • Introduction to uKit Explore Library
    • Sensor
      • uKit eye lamp
        • setEyelightAllPetals(id,red,green,blue)
        • setEyelightPetals(id,petalsnum,petals)
        • setEyelightLook(id,face,times,red,green,blue)
        • setEyelightLookUntil(id,face,times,red,green,blue)
        • setEyelightScene(id,scene,times);
        • setEyelightSceneUntil(id,scene,times)
        • setEyelightOff(id)
      • uKit Ultrasonic Sensor
        • setUltrasonicRgbled(id,red,green,blue)
        • setUltrasonicRgbledOff(id)
        • readUltrasonicDistance(id)
      • uKit Infrared Sensor
        • readInfraredDistance(id)
      • uKit Touch Sensor
        • readButtonValue(id)
      • uKit Light Sensor
        • readLightValue(id)
      • uKit Sound Sensor
        • readSoundValue(id)
      • uKit Temperature and Humidity Sensor
        • readHumitureValue(id,choice)
      • uKit Color Sensor
        • readColorRgb(id)
        • readColor(id,color)
    • uKit Servo Motor
      • setServoTurn(id,dir, speed)
      • setServoAngle(id,angle,times)
      • readServoAngleNPD(id)
      • readServoAnglePD(id)
    • uKit DC Motor
      • setMotorTurnAdj(id, speed,time)
      • setMotorTurn(id,pwmDuty)
      • setMotorStop(id)
      • readMotorSpeed(id)
    • uKit Explore Onboard Hardware
      • Onboard button
        • button1.Update();
        • button1.clicks()
      • Onboard Buzzer
        • noTone(pin)
        • tone(frequency, duration)
      • Onboard RGB LED
        • setRgbledColor(red,green,blue)
      • onboard Battery Voltage Level
        • readBatteryVoltage()
      • onboard Gyroscope
        • IMU::init()
        • IMU::read()
        • IMU::getRawAccelX()
        • IMU::getRawAccelY()
        • IMU::getRawAccelZ()
        • IMU::getRawGyroX()
        • IMU::getRawGyroY()
        • IMU::getRawGyroZ()
        • IMU::getRoll()
        • IMU::getPitch()
  • Arduino Function
Powered by GitBook
On this page

Was this helpful?

About uKit Explore

NextHow to Install uKit Explore Arduino Library

Last updated 5 years ago

Was this helpful?

Basically, uKit Explore is a board that is Arduino based designed for competition usage. It is carefully designed for beginner to be used as the controller for competition, it will help you to explore the wonderful electronics world and how fun the technology is.

In uKit Explore parts, it is divided into two category which are the electronics and building blocks. For electronics, it includes the Explore main controller board, motors and sensors. While for building blocks, it consists of the decoration parts as well as different type of connectors.

Electronic part
Structural part